Congratulations on your purchase!
So that you get the best from your new card holder, please read these brief instructions carefully:
The SafeCard holder section of the wallet is made of aluminium and titanium alloy and is used for holding cards. All cards are immediately to hand and your most important plastic cards are protected against any bending, distortion or breakage.
Also, your cards are protected against unwanted RFID (Radio Frequency Identification) readers and this prevents the information from your cards from being read, blocking readers from scanning your identity, credit cards, debit cards, banking information, driver licenses and other RFID cards.
How to use the wallet
The case is capable of holding from 4 up to 6 cards. The card protector can hold six cards if one has debossed (thickened) letters, five cards if three cards have debossed letters or four cards if all cards have debossed letters. Put the most used cards at the back of the wallet for optimal use. Gradually slide the cards out with the black handle in one movement in the direction of the arrow. The cards will then be immediately available cards if all cards have debossed letters. Put the most used cards at the back of the wallet for optimal use.
Slide the cards back into the holder after use. Cleaning can be done with a soft damp cloth and allow to dry before use.
Please note: If the button does not spring slowly back after use, please follow these steps below:
- Change the order of the cards, remove dirt by shaking, blowing or cleaning with warm water.
- Provides limited protection against strong magnets and is not suitable for cardboard business cards.
- The model is designed for plastic cards with standard credit card size. Cards that are smaller can be loose and fall out. Cards that are wider can damage the mechanism or may cause other cards to loosen or fall out.
Enjoy your wallet!